S P E C I F I C A T I O N S
(SUBJECT TO CHANGE)

• Dimensions (H × W × D)  :1.7 × 19.0 × 13.1 in (44 × 483 × 333 mm)
• Weight :10.1 lb (4.6 kg) without antennas   
• Housing  :Steel; extruded aluminum
• Power Requirements   :100 to 240 VAC, 50–60 Hz 0.68 A max
• Thermal Dissipation   :Maximum: 23 W (78 BTU/hr),Idle: 15 W

AUDIO OUTPUT  

• Gain Adjustment Range  :–18 to +42 dB in 1 dB steps (plus Mute setting)
• Configuration :1/4″ (6.35 mm): Transformer-coupled Balanced (Tip=audio, Ring=no audio,Sleeve=ground) XLR: Transformer-Coupled Balanced (1=ground, 2=audio +, 3=audio –)                     
• Impedance Typical, XLR Line Out  :100 Ω
• Full Scale Output  :200 kΩ load

                                     :1/4″ (6.35 mm): +8 dBV

                                     :XLR (LINE setting): +18 dBV

                                     :XLR (MIC setting): –12 dBV

• Mic/Line Switch   :30 dB pad
• Phantom Power Protection  :Yes

NETWORKING

• Network Interface  : 10/100 Mbps, 1 Gbps, Dante Digital Audio
• Network Addressing Capability  :DHCP or Manual IP address
• Maximum Cable Length  :100 m (328 ft)

CASCADE OUTPUT

• Connector Type  :BNC

                                    Note: For connection of one additional receiver in the same band

• Configuration     :Unbalanced, passive
• Impedance         :50 Ω
• Insertion Loss    :0 dB, typical

RF INPUT

• Spurious Rejection  :>80 dB, typical
• Connector Type  :BNC
• Impedance :50 Ω
• Bias Voltage :12-13.5 VDC, 150 mA maximium, per antenna, switchable on/off
• RF Carrier Frequency :Range
• Model-Dependent

        AD4D=A: 470–636 MHz

        AD4D=B: 606–810 MHz

        AD4D=C: 750–960 MHz